Some contract work this time. Veneering a small cabinet with some gloriously crazy burr ash. This was made as a copy of a piece of furniture that is no longer manufactured. Lots of cutting of veneer to create the patchwork.
The veneer as purchased is usually around 0.6 mm thick. My first step was to cut the veneer into strips of an appropriate width to give four or five rows on the sides of the finished cabinet. These strips were then randomly mixed up and using small strips of masking tape to hold them together they were glued along their edges. These new sheets of veneer were then further cut into strips of the same width and then randomised again before being similarly glued along their edges. And these were then also randomised and edge glued again so that I now had patchwork veneer sheets with which I could proceed to veneer my substrate.





The actual veneering of the substrate is done one panel at a time. A vacuum bag is used to press the veneer down evenly across the entire surface. The panels are trimmed to size and the edges of the panels were veneered with thinner strips which were applied using a hot iron. The carcass was mitred also and finally the feet were attached. The outside is finished with Osmo Honey, and the inside is finished with Rubio Monocoat Cortado.
A lot of work but quite a striking end piece.







